- Windows ( 7 or later) computer
- Faraday Utility
- Faraday M5 USB Diagnostic Cable
Step One: Disconnect the mode selector
Step Two: Connect the diagnostic cable to top tube cable and mode selector. Take care not bend any pins by lining up the arrows on the connectors.
Step Three: Connect the USB to your computer
Step Four: Open the Faraday Utility. Check there is a COM device highlighted in green. If you don't see this, click 'Refresh.'
Step Five: In order to test the connection, select 'System Info.' The console should print out similarly to the picture below. Cycle power to the bike if prompted.
Step Six: Select 'Motor Update.' In the file browser select the appropriate .xml file. If you have not downloaded the appropriate file yet you can find them here.
NCTE 43 11 Rev 3
|NCTE or THUN||
|plactic cup on BB|
|TDCM 43V 11 Rev3||TDCM||43V (Faraday)||metal lock ring on BB cup|
|THUN Rev4 36V||THUN||36V (8FUN)||platic cup on BB + 8FUN on motor|
Step Seven: The Utility should log a similar output to the image below. If so, the bike has been updated with the latest parameters. Carefully reconnect the mode selector and test ride the bike.